Denis They are nice beefy spicks, I went as far as making my own, but its slow going. I also have tried Peco spicks, wouldn't be common in the US, but eventually ordered Right of Way spicks, but I like those Verney ones. I also tried a Kadee spicker but prefer the pliers.
Holy cow Jim! you do have a couple laying around don't you! I could interested for sure, not sure I need al of em but who knows lol. The experiment is on going, working on some switches and a crossover currently. Learning what doesn't work so well in some cases too lol. So far those old Varney spikes have been working pretty good for me. I tried some of the newer Micro Engineering spikes, but they are a bit more slender and not quite up to my skill level or more likely my ties lol.
Not great work, but it is going a little..... I know it is a bit crude, but seems to track fairly well so far. And I may go ahead and cut the frog so I can insulate it for two rail.
Dennis if you have a Jewellers piercing saw or some other fine saw just cut the wed of the rail where you wont to bend the rail for your points, guard rails etc The "right of way" spicks need a relatively soft tie. The Verney spicks look great, nice and robust. I hate to think how much posting spicks to Australia might cost these days.The postage has gone nuts.
Small track laying update, I did formally install some outside third rail, camo earth paint like on the rail sides etc. I know it's pretty cheesy compared to most of the two rail stuff I see, but it's my first real attempt, I've learned some stuff that I would approach differently next time etc. Generally it's been cheap and easy if you excuse the time consuming part lol. Loco's seem to run well on it as well. I'm still not sure on ballast although thinking about trying some Brennen's ballast. And work on this section with the switches a bit....