How far do you dive in for repairs?

All Facets of O-Gauge, 3-Rail, Model Railroading
J. S. Bach
Posts: 5820
Joined: Wed May 16, 2007 9:30 pm

Re: How far do you dive in for repairs?

Postby J. S. Bach » Thu Feb 14, 2019 6:05 pm

rogruth wrote: ...snip... Sometimes my fingers are too big to handle those little bitty pieces. ...snip...

Same here.

tarheeltracks
Posts: 2
Joined: Sun Jan 28, 2018 2:44 pm

Re: How far do you dive in for repairs?

Postby tarheeltracks » Tue Apr 23, 2019 7:44 pm

If I have a problem be it a drive tire replacement to a TMCC problem I will try to fix it, or in some cases break it some more. As far as the TMCC problems it is pretty much a guessing game or board swaps if I have another locomotive with the same part that I think is the problem. For me after finding the problem the biggest headache is getting the part, but that's a whole other story.

User avatar
Mitch
Posts: 5215
Joined: Sat May 28, 2005 2:06 pm
Location: Freeport, Pa.

Re: How far do you dive in for repairs?

Postby Mitch » Sat Apr 27, 2019 7:07 pm

healey36 wrote:It was a great experience. The Old Man thought I was crazy. Built a set of speakers as well. Worked the first time I fired it up. I can still remember the glow of the tubes.


I did one of those HeathKit 4 channel CB radios back in the '60s from Allied Radio. Big tin box, a board that you soldered only a few wires, the tube sockets were already in there. It actually worked, but it was supposed to be a "mobile" unit, and the lower dashboard on the passenger side of a '53 Ford Truck wasn't up to holding 10 lbs. of radio. Hardly any room left for the passenger's legs. :lol: Now you get 40 channels in a little box 7" long, 5" wide, and 1 1/2" thick, weighs about a pound and a half. Transistors and microchips make a big difference. I tried soldering a burnt trace on a key board once. With my eyes and my big paws, I'm not goin' that route again.
If you agree with the Progressives, it's freedom of speech. If you disagree, it's hate speech. There are no alternatives.


Return to “O-Gauge, 3-Rail, Model Railroading”

Who is online

Users browsing this forum: No registered users and 19 guests