Uh-oh. My G1 has 80" drivers.
Never rode the Reading, but rode the PRR daily between Rosemont and 30th street station. I did see PRR steam on the Trenton Cutoff in Berwyn.
Paul Egolf ..in the beginning
- ScaleCraft
- Posts: 6693
- Joined: Thu Jan 26, 2012 10:15 pm
Re: Paul Egolf ..in the beginning
So.
Old engine.
For sure an Egolf.
NOT a Pennsy nor a K4s.
Reading G something.
Provenance and originality? Hard to say. Wrong Pennsy tender, and bets are good Egolf did not produce a Reading Pacific with a Pennsy tender.
Pilot truck missing. Going to be hard to find an original to keep it era-sensitive. Were the wheels spoked or plain?
Paint is a goner. Was the applique on the firebox and over the reverse rod factory? Never seen any engine that had anything like that there.
Strip and paint.
So, again, an Egolf with missing pilot ruck, needs full strip and repaint, needs to find a correct tender, and then it's a repaint/rebuild.
Done far too many of those where parts are somewhat available.
Old engine.
For sure an Egolf.
NOT a Pennsy nor a K4s.
Reading G something.
Provenance and originality? Hard to say. Wrong Pennsy tender, and bets are good Egolf did not produce a Reading Pacific with a Pennsy tender.
Pilot truck missing. Going to be hard to find an original to keep it era-sensitive. Were the wheels spoked or plain?
Paint is a goner. Was the applique on the firebox and over the reverse rod factory? Never seen any engine that had anything like that there.
Strip and paint.
So, again, an Egolf with missing pilot ruck, needs full strip and repaint, needs to find a correct tender, and then it's a repaint/rebuild.
Done far too many of those where parts are somewhat available.
Dave....gone by invitation
Return to “O-Gauge, 2-Rail, Model Railroading”
Who is online
Users browsing this forum: Bing [Bot] and 46 guests