Weaver GP38s

Discuss All Facets of 2-Rail, 1/48 Scale, Model Railroading
ogauge47

Weaver GP38s

Postby ogauge47 » Tue Mar 20, 2018 5:00 pm

Hey all! Looking to get back into the swing of things with a GTW GP38-2 build. The Grand Trunk units did not have dynamic brakes, and as we know the early Weaver models came from the factory with them. Are the side housings removable or does the entire hood section need to be removed and replaced? I am really hoping to not have to cut and patch the body more than I absolutely need to. (I assume the DB fan will need to be cut out)

Thanks!

User avatar
sarge
Posts: 5138
Joined: Thu Apr 02, 2009 2:21 pm
Location: Dungfield Manor

Re: Weaver GP38s

Postby sarge » Tue Mar 20, 2018 5:41 pm

Here you go.

image.jpeg


You do have to fuss the fan off or you could saw off the airbox then build a new after-section of styrene, but this shows how it comes apart and the component bits.

Helpful?

ogauge47

Re: Weaver GP38s

Postby ogauge47 » Tue Mar 20, 2018 6:00 pm

Just what I needed, thank you!

The first few GP38's I did back about 6 years ago were the first few of DT&I 200 series, which DID have DBs. Those were K-Line models and not fun at all to work with

Image

User avatar
sarge
Posts: 5138
Joined: Thu Apr 02, 2009 2:21 pm
Location: Dungfield Manor

Re: Weaver GP38s

Postby sarge » Tue Mar 20, 2018 8:40 pm

The Weaver is actually a 38-2 while the K-line an earlier GP38, the wider spacing of the after fans are the big tip-off, just so you're aware of it (You probably are, but mentioned just in case). Not a bad match for the GTW 4900 series. Watch the trucks as the Weaver are earlier outside hung brakes and no snubbers. At least some of GTWs units had them so you should be good so long as you check which one you're doing.

Shoving the horn back off the cab would be easy and well worth doing for "the look", too.

I've never had occasion to work with the K-line, but the Weaver shell is nice to work with, actually.

ogauge47

Re: Weaver GP38s

Postby ogauge47 » Wed Mar 21, 2018 11:46 am

sarge wrote:The Weaver is actually a 38-2 while the K-line an earlier GP38, the wider spacing of the after fans are the big tip-off, just so you're aware of it (You probably are, but mentioned just in case). Not a bad match for the GTW 4900 series. Watch the trucks as the Weaver are earlier outside hung brakes and no snubbers. At least some of GTWs units had them so you should be good so long as you check which one you're doing.

Shoving the horn back off the cab would be easy and well worth doing for "the look", too.

I've never had occasion to work with the K-line, but the Weaver shell is nice to work with, actually.


Thanks for the info! The Weaver should be perfect then. The 4900’s were ex-MP units with the leaf spring Blomburg trucks, outside brake hangers and wide spaced fans. The one detail to add would be the additional jack pads underneath the cab.


Return to “O-Gauge, 2-Rail, Model Railroading”

Who is online

Users browsing this forum: No registered users and 56 guests