Design Issues?
Posted: Fri Dec 25, 2020 11:50 pm
I don't know if this would even work without a lot of noise, or for how long.
Interesting piece, probably a lot of vintage provenance.
I would be willing to bet the brass bars underneath holding the sideframes together is a problem.
Of course, without hands-on, hard to be certain, but it appears the metal chains are dragging on the bars, actually lifted by the same bars. Had to have been NOISY in operation.
The chains look quite shiny where they have rubbed on the brass bars.
Almost like it needs rods between sideframes that go through the middle of the chains, but not sure how to hide their attachment to the sideframes....soldered to plates, 2-56 into the back of the sideframes?
Or just bridge strengthen across the top and down inside.
Nice outside third rail whiskers. Don't know how Carey missed that one.
https://www.ebay.com/itm/O-Scale-Two-Ra ... 3066814712
Interesting piece, probably a lot of vintage provenance.
I would be willing to bet the brass bars underneath holding the sideframes together is a problem.
Of course, without hands-on, hard to be certain, but it appears the metal chains are dragging on the bars, actually lifted by the same bars. Had to have been NOISY in operation.
The chains look quite shiny where they have rubbed on the brass bars.
Almost like it needs rods between sideframes that go through the middle of the chains, but not sure how to hide their attachment to the sideframes....soldered to plates, 2-56 into the back of the sideframes?
Or just bridge strengthen across the top and down inside.
Nice outside third rail whiskers. Don't know how Carey missed that one.
https://www.ebay.com/itm/O-Scale-Two-Ra ... 3066814712