Page 1 of 1
Fixing dents in Brass
Posted: Wed Aug 05, 2020 10:36 am
by E7
Maybe turn a sow's ear into a silk purse? Burnishing would be one technique.
Anyone car to share their experience/experiences on this topic?
Re: Fixing dents in Brass
Posted: Wed Aug 05, 2020 11:27 am
by bob turner
Just like auto body work. Gentle taps with a hammer against a dead-flat, smooth, heavy dolly. Be very careful not to expand the metal or excessively work-harden it. Putty or JB Weld is the finishing touch.
Re: Fixing dents in Brass
Posted: Wed Aug 05, 2020 11:38 am
by De Bruin
Rich, do you have a specific example that's vexing you? maybe a photo there of?
Thanks to frequently crappy packaging with Ebay purchases
I'm sure many of us here have some legit experience with those kinds of repairs; dented brass, bent frames etc.
I certainly have.
Re: Fixing dents in Brass
Posted: Wed Aug 05, 2020 12:16 pm
by Rufus T. Firefly
I have a large anvil,

And a smaller one in my shop on the table under the band saw.

Putty or JB Weld is the finishing touch.
I have made use of similar materials once "close enough" or in a few cases where I was going to probably cause more damage while fixing the dent.
Re: Fixing dents in Brass
Posted: Wed Aug 05, 2020 1:01 pm
by E7
De Bruin wrote:Rich, do you have a specific example that's vexing you? maybe a photo there of?
Thanks to frequently crappy packaging with Ebay purchases
I'm sure many of us here have some legit experience with those kinds of repairs; dented brass, bent frames etc.
I certainly have.
Pete,
Just a topic that hopefully might be of value to someone. Maybe turn a buy with a caveat into a great deal. I am aware that metal can be streched from my hot rod days. I'm thinking burnishing might be the primary path to pursue. Maybe a source for tools?
Thanks!
Re: Fixing dents in Brass
Posted: Wed Aug 05, 2020 1:31 pm
by E7
Rufus T. Firefly wrote:I have a large anvil,

And a smaller one in my shop on the table under the band saw.
I had an instructor waaay back that used to say: "You look like the kinda guy that could break an anvil." Kinda made you feel special.

Re: Fixing dents in Brass
Posted: Wed Aug 05, 2020 1:49 pm
by bob turner
Burnishing works sometimes. Half-hard brass needs to be coaxed. The Lobaugh etched Challenger tender sides were dead soft, and always wrinkled. burnishing works on them. Hammering would destroy the rivets. But dead-soft brass does not make good models - maybe gaskets?