Page 1 of 1

E units Identity please

Posted: Sat Oct 21, 2017 4:35 pm
by Carey Williams
Hello all

Can any one identify a pair of E units ? ....please

Body seems to be brass ... cast pilot , back , under belly , thick brass frame older type of trucks and drive .... modified to 3 rail with tinplate couplers and flanges. Nicely painted and signed by artist "Buck Cleveland" ...from 2002 ..... each unit is 10 pounds and 18" long ....

Any help appreciated .

Cheers Carey

IMG_6234.JPG
IMG_6234.JPG (1.55 MiB) Viewed 4830 times


IMG_6230.JPG
IMG_6230.JPG (1.55 MiB) Viewed 4830 times


IMG_6235.JPG
IMG_6235.JPG (1.29 MiB) Viewed 4830 times


IMG_6232.JPG
IMG_6232.JPG (931.22 KiB) Viewed 4830 times


IMG_6233.JPG
IMG_6233.JPG (1.62 MiB) Viewed 4830 times

Re: E units Identity please

Posted: Sat Oct 21, 2017 5:41 pm
by rogruth
Look nice in the photos.

Re: E units Identity please

Posted: Sat Oct 21, 2017 5:54 pm
by Erik C Lindgren
Yeah those are sweet :D

Re: E units Identity please

Posted: Sat Oct 21, 2017 8:32 pm
by bob turner
Don't know for sure - but I am officially jealous. They might be Jack Raymus bodies - look for Adams & Son logo on the inner roof.

Re: E units Identity please

Posted: Sat Oct 21, 2017 11:56 pm
by bob turner
Not Raymus bodies. Note the difference in aspect ratio of those side windows. Here is mine - time to solder it together.

image.jpg
image.jpg (864.84 KiB) Viewed 4765 times

Re: E units Identity please

Posted: Sun Oct 22, 2017 4:16 pm
by stephen neill
These are quite different from the more common units we see. I have a set of Pamona Valley diesels that are in some ways similar. But only in some ways, and then only similar. Does anyone else have PV diesels they can compare to these? Are the ends truly a casting and not brass sheet with a casting soldered to it?

Steve

Re: E units Identity please

Posted: Mon Oct 23, 2017 1:01 am
by Carey Williams
Hello all
Thank you for your kind comments...I forgot to add the photo showing the artist's signature ... and the over all interior construction ....seems to be all brass sheets soldered together ...( way above my pay scale ....)
Steve I'll re check the back of the engines to see construction ..they are unique .

Cheers Carey

IMG_6231.JPG
IMG_6231.JPG (1.59 MiB) Viewed 4699 times

Re: E units Identity please

Posted: Mon Oct 23, 2017 12:57 pm
by Carey Williams
Hello all

I stand corrected ..the ends are flat brass and a thicker piece soldered in the center .... pilot appears to be carved/ machined / whittled ? out of solid brass ...so no castings on the body .... truck frames yes....

during the rebuild / repaint ...the engine was 3 railed ( center rail ... oh no !) .. tinplate wheels swapped out on the non drive trucks ..so it will be an easy switch back to match the drive wheels .

So did someone scratch build the entire engine and add old trucks ? ( which may not have been new at the time of the construction) .

Cheers Carey

Re: E units Identity please

Posted: Mon Oct 23, 2017 3:05 pm
by bob turner
Not a chance they were early Japanese imports?