I'll add a photo here for Bob, since we're talking about them now.
These things came in several models and configurations. Mine is indeed a C.
The headstocks came with either a three-sheave flat belt or a four-sheave V-belt. Most commonly they came with a high/low intermediate off the motor so either six or eight speed.
Mine is a little more unusual in that it has a four-sheave intermediate so it is a #715 16-speed Model C, manual change gears, and back-geared. The cross-slide is powered and reversible in the long axis and the short axis is manual.
I do like the spindle speeds I can get, very handy range for nice finishes in brass and decent aluminium parts, yet still works steels nicely and can go even slow enough for plastics without melting.
I'm all in with Joe about collets and potchucks; this has a "short set" (not a full by 64ths range, but the common sizes with enough overlap) as well as milling cutter holders and drawbar, since it came with a milling head (third axis and rotation) for the crosslide, turning it into a pretty decent albeit rudimentary horizontal mill for small bits.
I really do like it, but I need to either sell it on or completely reconfigure my basement and bring it in there in a controlled environment. Right now its out in my car shop, and oddly enough its the winter that is hardest on it; temp cycles near freezing and the condensation is something I continually have to watch like a hawk.
So, if it doesn't sell then I'll get it rigged into the cellar this fall at the cost of some layout space and where a smaller 4" lathe sits now. For me, its overkill but delicious and fun overkill, but not much fun moving the tooling in and out over the winter and the weekly oiling the ways from mid November to mid-March.
So, here you are, Bob. Truly stout bench, BTW. Grin!
IMG_3182.JPG