Page 1 of 1

Bridges, spikes, and tie plates ... and

Posted: Fri Mar 31, 2017 12:01 am
by Erik C Lindgren
Small update.. on my bridge project --I know I've shared some of these with the other place down the hall.. some of you don't go over there. . . OK I know I should come here but I needed to remind some that I am still there.


Drawing I made last Fall (review)
IMG_3527.JPG
IMG_3527.JPG (484.72 KiB) Viewed 5098 times


IMG_2628.JPG
IMG_2628.JPG (1.48 MiB) Viewed 5098 times
IMG_2626.JPG
IMG_2626.JPG (143.65 KiB) Viewed 5098 times
IMG_4877.JPG
IMG_4877.JPG (964.17 KiB) Viewed 5098 times
IMG_2621.JPG
IMG_2621.JPG (1.68 MiB) Viewed 5098 times

Re: Bridges, spikes, and tie plates ... and

Posted: Fri Mar 31, 2017 8:49 am
by Rufus T. Firefly
More info on this, please

Erik C Lindgren wrote:......but I needed to remind some that I am still there.


Why?

Could post on OST as well........

Re: Bridges, spikes, and tie plates ... and

Posted: Fri Mar 31, 2017 9:03 am
by up148
Your level of detail and quality of build is excellent as always Erik. Love that bridge.

BH

Re: Bridges, spikes, and tie plates ... and

Posted: Fri Mar 31, 2017 9:25 am
by Big Jim
That looks much better Eric! Nice job Lad!!

Re: Bridges, spikes, and tie plates ... and

Posted: Fri Mar 31, 2017 1:04 pm
by bob turner
Once you get to that level of detail, you have to stick to five foot gauge so we can tell it is not real, at least when rolling stock is present.

Re: Bridges, spikes, and tie plates ... and

Posted: Fri Mar 31, 2017 9:15 pm
by Erik C Lindgren
So right bud!

Hahahah ;-)

Thank you Guys... it's been an S-Load of work. John Johnson appreciates the fine compliments too.