Atlantics 2023

Discuss All Facets of 2-Rail, 1/48 Scale, Model Railroading
bob turner
Posts: 13675
Joined: Sat Jan 13, 2007 7:57 pm

Re: Atlantics 2023

Postby bob turner » Sun Mar 26, 2023 9:05 pm

If you mean the sand dome, yes - a few of the early E6s had the H10 sand dome. Any other discrepancy was inadvertent.

User avatar
De Bruin
Posts: 991
Joined: Thu Jan 12, 2017 8:24 pm

Re: Atlantics 2023

Postby De Bruin » Sun Mar 26, 2023 10:39 pm

I like your Atlantics there Bob; both but for different reasons aside from the impressive boiler and driver size.
I also have to admit to never getting tired of seeing Dick Garberson's work either, and I have never seen this example either.
R.K. Maroon wrote:Image

Image
.....This was custom-built by Bob Hall....It needs servicing but I don't believe it has any major issues (famous last words).
Jim

Remarkable amount of fidelity here (albeit not perfect but good enough for me) given this class comparison between Dick's and one class road number down from George Elwoods site (*ahem* which I financially support so I can post photos like this.)
Cheers all.
Political Consultant- Tap into the hidden powers of your public office, insure your future is jail free, well funded. Visit shock and awe upon your adversaries, dominate the media, thrill your followers. contact morbo@happydaysrhereagain.com

User avatar
R.K. Maroon
Posts: 3140
Joined: Tue Feb 22, 2011 9:20 pm

Re: Atlantics 2023

Postby R.K. Maroon » Mon Mar 27, 2023 12:41 pm

bob turner wrote:Any other discrepancy was inadvertent.

OK -- I looked at the two photos again more carefully. I think I was fooled by small differences in camera angle and lighting more than anything else.

De Bruin wrote:I never getting tired of seeing Dick Garberson's work either

Pete reminds me that I didn't give credit to Richard Garberson, who did the paint and decal finish work on all the CB&Q models built by Bob Hall and maybe some of the non-CB&Q models too. If clothes make the man then it could be said that finish makes the model.

Thanks for the prototype photo, Pete -- It really looks long and lanky from that angle.

Jim
The link below any photo will display the image full size

User avatar
ScaleCraft
Posts: 6693
Joined: Thu Jan 26, 2012 10:15 pm

Re: Atlantics 2023

Postby ScaleCraft » Mon Mar 27, 2023 3:26 pm

I have an aversion to Atlantics. If I get close to one, I break out.
Heebee Jeebies. Shakes.

All goes back to the early 60's and a Roundhouse H0 Atlantic. NOW I know it was probably zamac rot in the drivers, but we could not keep it going. Finally deep-sixed it.
Dave....gone by invitation

E7
Posts: 8404
Joined: Wed Dec 12, 2007 1:35 am

Re: Atlantics 2023

Postby E7 » Tue Mar 28, 2023 11:49 am

ScaleCraft wrote:I have an aversion to Atlantics. If I get close to one, I break out.
Heebee Jeebies. Shakes.


They're definitely NOT my favorite thing on rails.

bob turner
Posts: 13675
Joined: Sat Jan 13, 2007 7:57 pm

Re: Atlantics 2023

Postby bob turner » Tue Mar 28, 2023 12:53 pm

For a long time they were not mine either. I still have a list of steamers I do not care for, but I have managed to remove Atlantics and the PRR T1 from that list. I still cannot abide modern automotive styling, and do not care for the Cirrus aircraft appearance.

Forumites can easily discern my tastes in trains - for the rest of it, the best auto design was the 1965 Mustang; best truck was the 1946 Autocar; best airplane the Piper Cub. Opinion.

User avatar
ScaleCraft
Posts: 6693
Joined: Thu Jan 26, 2012 10:15 pm

Re: Atlantics 2023

Postby ScaleCraft » Tue Mar 28, 2023 2:09 pm

bob turner wrote:For a long time they were not mine either. I still have a list of steamers I do not care for, but I have managed to remove Atlantics and the PRR T1 from that list. I still cannot abide modern automotive styling, and do not care for the Cirrus aircraft appearance.

Forumites can easily discern my tastes in trains - for the rest of it, the best auto design was the 1965 Mustang; best truck was the 1946 Autocar; best airplane the Piper Cub. Opinion.


40 Ford Tudor.
50's Mack B series with air seat
Helio Courier :lol:
Dave....gone by invitation

bob turner
Posts: 13675
Joined: Sat Jan 13, 2007 7:57 pm

Re: Atlantics 2023

Postby bob turner » Tue Mar 28, 2023 2:19 pm

I have experience in the Helio. Great for short jungle strips; lousy for most other purposes. A horrible flying slug, but with good slow speed capabilities.

Cessna 180 was preferred by the missionary community (do not care for proselytization, but admired their pilots).

bob turner
Posts: 13675
Joined: Sat Jan 13, 2007 7:57 pm

Re: Atlantics 2023

Postby bob turner » Tue Mar 28, 2023 2:22 pm

And happily (?) we have finished Atlantics, and this thread can go wild. My only lament is that so few of us have photos of Atlantics to share.

And why does spell check think Atlantics is always possessive? Took me precious minutes to delete all those apostrophes.

User avatar
ScaleCraft
Posts: 6693
Joined: Thu Jan 26, 2012 10:15 pm

Re: Atlantics 2023

Postby ScaleCraft » Tue Mar 28, 2023 2:42 pm

bob turner wrote:I have experience in the Helio. Great for short jungle strips; lousy for most other purposes. A horrible flying slug, but with good slow speed capabilities.

Cessna 180 was preferred by the missionary community (do not care for proselytization, but admired their pilots).


I worked with Wycliffe in the jungles. Using Helios.
Other places did use Cessnas, MAF I think started with Pipers (I remember them slipping into Fullerton airport), New Tribes was Cessna.
I led accident investigation and component recovery on a Helio. HK612P. No question I'd fly in one again.
Dave....gone by invitation

User avatar
De Bruin
Posts: 991
Joined: Thu Jan 12, 2017 8:24 pm

Re: Atlantics 2023

Postby De Bruin » Wed Mar 29, 2023 8:35 pm

bob turner wrote:And happily (?) we have finished Atlantics, and this thread can go wild.....

Not so fast mon frerer
Image
Since I recall you scorn these Atlantic variants of the All Nation short boiler, and apparently the wheel class in general revolts some of our regulars here let me oblige 8^)
Image
I believe this was another build by the late great Arthur Hambrick and hence an extremely reliable runner albeit some decades later worn out and requiring some rebuilding around ten years ago(?), which I recall posting about here as per the first photo above. Despite some boiler and frame casting fractures it was still a great running locomotive able to walk off with a five-car string of Walthers/AN/Lobaugh HW psgr cars, way above it's weight class.
One of my faves.
Political Consultant- Tap into the hidden powers of your public office, insure your future is jail free, well funded. Visit shock and awe upon your adversaries, dominate the media, thrill your followers. contact morbo@happydaysrhereagain.com

User avatar
De Bruin
Posts: 991
Joined: Thu Jan 12, 2017 8:24 pm

Re: Atlantics 2023

Postby De Bruin » Wed Mar 29, 2023 8:54 pm

Oh yeah; 67 Malibu SS, 62 IH Scout, and that Rutan Stargazer zipping over my house once a week on Fridays, going fishing in Florida from Atlanta PDK.
My old man was a SkyMaster fan and I know he would've coveted that little jewel too.
Political Consultant- Tap into the hidden powers of your public office, insure your future is jail free, well funded. Visit shock and awe upon your adversaries, dominate the media, thrill your followers. contact morbo@happydaysrhereagain.com

bob turner
Posts: 13675
Joined: Sat Jan 13, 2007 7:57 pm

Re: Atlantics 2023

Postby bob turner » Wed Mar 29, 2023 10:17 pm

Nice, Pete. The more Atlantics the better. My current effort? Just spent two frustrating hours trying to get that simple beam with the trailing truck bearings installed. Kept making mistakes. Same with lead truck - maybe I am "losing it."

Tonight I straighten the feedwater and air pumps - also currently crooked.

User avatar
R.K. Maroon
Posts: 3140
Joined: Tue Feb 22, 2011 9:20 pm

Re: Atlantics 2023

Postby R.K. Maroon » Thu Mar 30, 2023 1:15 pm

I had to look up all those aircraft you guys mentioned. My tastes are more tame. Back in my motorcycle riding days, I was attracted to highway cruisers instead of trail bikes or death rockets. Water cooled and shaft drive with a fairing suited me fine (and was conducive to a daily commute). And though I never became a pilot, I had similar thoughts about airplanes -- a Cessna 310 seemed like it would be a nice cruiser to have, as long as you had money to burn and places to go. I had neither.

I got a ride once in a Grumman Widgeon down in the Florida Keys. It had been re-engined and equipped with variable-pitch props. I was surprised how well it climbed and turned. We did a few low-level passes over the divers out on the reefs. My guess that the ownership and operating costs matched or exceeded the 310, but I will admit it was a lot of fun. I also got a ride once with Bob in his Cub. I had taken the controls in a Cessna on a couple of occasions in the past. That was interesting but honestly not really much fun. Bob let me stick around the Cub. Now that was fun.

I serviced the Bob Hall CB&Q Atlantic the other night and took it over to Michael Ross's layout for a test spin yesterday. We had a big scenery project to finish, so I only had time for a once around while running light. It's a smooth runner. Short video here:

https://www.dropbox.com/s/ymddoi2ju4sjcuw/Bob%20Hall%204-4-2%20CB%26Q%202591.mp4?raw=1
The link below any photo will display the image full size

E7
Posts: 8404
Joined: Wed Dec 12, 2007 1:35 am

Re: Atlantics 2023

Postby E7 » Thu Mar 30, 2023 3:34 pm

I like the little freight wagon in Pete's one pic. Looks like the engine once belonged to the late Lorell Joiner ("Great Southern")


Return to “O-Gauge, 2-Rail, Model Railroading”

Who is online

Users browsing this forum: No registered users and 38 guests