There's been so many of you sending me PMs asking me..
1) How do a Farmall 450's brakes work?
2) How are they different from a car?
... that I took off the brake housing to demonstrate.
Here's the housing looking at it as though you were inside the final-drive case.
The arrow points to the articulated arm on which the brake arm pulls, (the dust boot removed).
Top layer is one of the two discs, which bears on a wear surface on the final-drive case, and a wear-surface on the 'actuator' beneath..

Next layer is the actuator, consisting of two plates, constrained by three lugs cast into the housing. As the articulated arm is pulled, the upper plate rotates clockwise, the lower plate counter-clockwise, their motion limited by the 'dog' on each plate, the limits of travel shown by the arrows.
If, in moving that distance, the discs don't engage their respective wear-surfaces, you have no brakes. The adjustment of such will be described later.

Next layer is the outer (relative to the tractor) disc.

Finally, the wear-surface of the housing, (with a nice mirror finish).

Here, the actuator assembly. The two plates are constrained to each other, and made to move to their 'home' positions, by 3 strong springs that connect the plates via the 3 sets of lugs on their inner diameters.
The plate wear-surface is uneven, but this is a tractor and not a race-car, and I've been assured, on a tractor forum, that neither pits nor unevenness are an issue, and all that need be done is to remove the glaze from all four wear-surfaces.

A quick demonstration, via a pull on the articulated arms. At rest...

... and under tension, where one can see 1) that they have rotated respective to each other, and 2) that they have gained distance between them, which is the motion that causes the discs to bear against their wear-surfaces.

Lastly, the cause of the plates moving apart... 5 steel balls with ramps. The spring pressure cause them to climb the ramps rather than spin in-place.

The adjustment of tolerance is pretty primitive. Once everything is cleaned, all glazes of wear-surfaces and discs carefully sanded in radial directions, carefully and lightly lubed on metal-to-metal surfaces, and restacked in the housing, there should be .030" to .060" distance between the top disc, and a straightedge placed across the face of the housing. If the clearance is too large (even .100 being too much), the clearance is reduced by milling the proper amount off the face of the housing. No other way to do it.
The difference from a car, of course, is that on a car, the wear-surfaces rotate and the 'pads' are stationary. On the 450, the roles are reversed.
And there you have it.
Now everyone can sleep peacefully tonight.
You're welcome.
