Whatzit?
Re: Whatzit?
Probably has nothing to do with trains.
roger
I support thread drift.
If God didn't want women to be looked at, He would have made 'em ugly. RAH
I support thread drift.
If God didn't want women to be looked at, He would have made 'em ugly. RAH
Re: Whatzit?
Part of the sign actually says "Tower" on it. The building is actually in two parts. The section facing the viewer was added on. There is an exhaust vent and an AC unit on the sole "window". The door at ground level has an indicator above it, possibly part of a safety alarm system. The door on the upper level with no staircase is pretty common in communications structures where large/heavy equipment can be brought in/out where stairs would be difficult. There appears to be an emergency/standby generator peeking out around the corner just off the telephone pole marked 128 (dark green object). I suspect the rear part of the building is some kind of communications substation.
The "front" part appears to be a yard or interlocking tower. There are at least six sets of tracks visible in the foreground, one set is diverging. Either a crossing or a switch? The rail tops are shiny so this is an active rail site with a decent amount of traffic. This is either a main crossing or possibly a classification yard. The "balcony" and the windows appear to be facing away from the viewer. The vertical tower on the right hand side of the photo appears to be a radio mast while the skinny (and taller) one further right looks like a yard light pole, one of many I would expect. There appear to be a couple of freight cars on the right hand side as well, one looks like a covered hopper.
The "front" part appears to be a yard or interlocking tower. There are at least six sets of tracks visible in the foreground, one set is diverging. Either a crossing or a switch? The rail tops are shiny so this is an active rail site with a decent amount of traffic. This is either a main crossing or possibly a classification yard. The "balcony" and the windows appear to be facing away from the viewer. The vertical tower on the right hand side of the photo appears to be a radio mast while the skinny (and taller) one further right looks like a yard light pole, one of many I would expect. There appear to be a couple of freight cars on the right hand side as well, one looks like a covered hopper.
Once I built a railroad, I made it run,
Made it race against time.
Once I built a railroad, now it's done --
Brother, can you spare a dime?
Made it race against time.
Once I built a railroad, now it's done --
Brother, can you spare a dime?
Re: Whatzit?

----Wayne----
Back when I was growing up, if you didn't start someth'n, there wouldn't be noth'n.
--Merle Haggard
Back when I was growing up, if you didn't start someth'n, there wouldn't be noth'n.
--Merle Haggard
- MurphOnMillerAve
- Posts: 18489
- Joined: Fri Jul 18, 2008 10:18 pm
- Location: Kennywood Park
- Contact:
Re: Whatzit?
The tower is now used for monitoring vehicular traffic on the nearby highway in the photo's background (?)
Re: Whatzit?
BIG hint. In this photo, A is the tower, B is my location where I took the Whatzit photo.


----Wayne----
Back when I was growing up, if you didn't start someth'n, there wouldn't be noth'n.
--Merle Haggard
Back when I was growing up, if you didn't start someth'n, there wouldn't be noth'n.
--Merle Haggard
Re: Whatzit?
According to a CSX map of the Radnor Yard in Nashville Tennessee is a Classification Tower (note "D").

This is a "simulated" 3d view from a Google Earth grab


This is a "simulated" 3d view from a Google Earth grab

Once I built a railroad, I made it run,
Made it race against time.
Once I built a railroad, now it's done --
Brother, can you spare a dime?
Made it race against time.
Once I built a railroad, now it's done --
Brother, can you spare a dime?
Re: Whatzit?
You got it, Chuck, it is one of the classification towers in CSX's Radnor yard, Nashville, TN.
This one is located at the exit to the gravity classification yard.
There is another classification yard at the site but after closing the gravity yard and using the other yard to sort cars CSX discovered having engines pushing cars in and out of a flat yard was not cost effective in terms of time, fuel, equipment and manpower, so they opened the gravity yard back up.
Reference: https://www.trains.com/trn/news-reviews ... nashville/
This one is located at the exit to the gravity classification yard.
There is another classification yard at the site but after closing the gravity yard and using the other yard to sort cars CSX discovered having engines pushing cars in and out of a flat yard was not cost effective in terms of time, fuel, equipment and manpower, so they opened the gravity yard back up.
Reference: https://www.trains.com/trn/news-reviews ... nashville/
----Wayne----
Back when I was growing up, if you didn't start someth'n, there wouldn't be noth'n.
--Merle Haggard
Back when I was growing up, if you didn't start someth'n, there wouldn't be noth'n.
--Merle Haggard
Re: Whatzit?
"Hump"/gravity yards are not as effective as they once were as more and more cars/freight wind up in a "no hump" classification. No hump intermodal, container, auto racks, ..... The days of GP loads are pretty much gone. Cars still suitable for "humping" are mostly bulk carrying hopper's, e.g. grain, plastic pellets, .... Unit trains for energy products generally don't require "classification", just re-routing and head end power changes. These have almost become giant conveyor belts.
Yards are switching over to an "RPV" model with operators with an elaborate control device (like a souped up game/RC controller) that they wear to control the locomotives doing the shunting and to control of the switches. I suspect that the only reason the guys are actually out in the yard are to deal with recalcitrant equipment as the folks in the tower could be using flying drones to monitor everything and the same RC controls for the "locomotives".
The choice to use gravity/flat may have more to do with what is being routed through a given yard than some traditional "cost savings". If only 20% of the cars can be gravity sorted it's unlikely the savings will cover the costs of the 80% that can't be gravity sorted.
Yards are switching over to an "RPV" model with operators with an elaborate control device (like a souped up game/RC controller) that they wear to control the locomotives doing the shunting and to control of the switches. I suspect that the only reason the guys are actually out in the yard are to deal with recalcitrant equipment as the folks in the tower could be using flying drones to monitor everything and the same RC controls for the "locomotives".
The choice to use gravity/flat may have more to do with what is being routed through a given yard than some traditional "cost savings". If only 20% of the cars can be gravity sorted it's unlikely the savings will cover the costs of the 80% that can't be gravity sorted.
Once I built a railroad, I made it run,
Made it race against time.
Once I built a railroad, now it's done --
Brother, can you spare a dime?
Made it race against time.
Once I built a railroad, now it's done --
Brother, can you spare a dime?
Re: Whatzit?
chuck wrote:"Hump"/gravity yards are not as effective as they once were as more and more cars/freight wind up in a "no hump" classification. No hump intermodal, container, auto racks, ..... The days of GP loads are pretty much gone.
No reason not to hump the empties returning north to be loaded up for another trip south. There were long strings of autoracks in the hump yard.
Google Earth view of Radnor hump yard.

----Wayne----
Back when I was growing up, if you didn't start someth'n, there wouldn't be noth'n.
--Merle Haggard
Back when I was growing up, if you didn't start someth'n, there wouldn't be noth'n.
--Merle Haggard
Re: Whatzit?
Name of this Whatzit, "RADNOR BOWL TOWER CSX."


----Wayne----
Back when I was growing up, if you didn't start someth'n, there wouldn't be noth'n.
--Merle Haggard
Back when I was growing up, if you didn't start someth'n, there wouldn't be noth'n.
--Merle Haggard
Re: Whatzit?
Whatzit?

Hint: It is among the many April wildflowers growing alongside my driveway here in Kentucky.

Hint: It is among the many April wildflowers growing alongside my driveway here in Kentucky.
----Wayne----
Back when I was growing up, if you didn't start someth'n, there wouldn't be noth'n.
--Merle Haggard
Back when I was growing up, if you didn't start someth'n, there wouldn't be noth'n.
--Merle Haggard
Re: Whatzit?
Empty auto racks can be humped but an increasing number of other cars can't be whether they are loaded or not, e.g. tank cars. They are just too "delicate". Some of the intermodal/container carriers can also be seriously damaged even when empty. A car with "no hump" stenciled on the ends or sides usually means "no hump" period. It's pretty rare to see a long freight train of mixed cars.
Most of the stuff I see around here are basically unit or near unit trains. The later is often a 50/50 split of two types of cars, e.g. tank cars and covered hoppers with a pretty easy to spot break between the two types. Most of the trains are all container or intermodal or all hoppers destined for some large distribution center. The train is broken up for unloading at some elaborate terminal or shunting to another carrier/line.
I remember it was kind of fun watching an 80 car freight where it seemed like every car was different. Not just different owners/markings. I mean really different, flat cars with all kinds of loads, gondola's, hoppers, freight cars, different style tank cars. Now I see strings of hopper cars with literally the same markings and damn near sequential numbers. It's like the rail line has become a giant conveyor belt.
BTW while researching this, I came across some news reports out of Nashville that the community would like CSX to "move the yard" so they can install a commuter/light rail line! This complex is the second largest yard complex in the Eastern US. Most importantly, the estimated cost to move the operation is $500 million dollars (yes, .5 billion) and I have no idea where they would move it too (let alone come up with the money to do so). CSX already occupies the most logical/reasonable site. The people proposing this are gold plated flaming *holes.
Most of the stuff I see around here are basically unit or near unit trains. The later is often a 50/50 split of two types of cars, e.g. tank cars and covered hoppers with a pretty easy to spot break between the two types. Most of the trains are all container or intermodal or all hoppers destined for some large distribution center. The train is broken up for unloading at some elaborate terminal or shunting to another carrier/line.
I remember it was kind of fun watching an 80 car freight where it seemed like every car was different. Not just different owners/markings. I mean really different, flat cars with all kinds of loads, gondola's, hoppers, freight cars, different style tank cars. Now I see strings of hopper cars with literally the same markings and damn near sequential numbers. It's like the rail line has become a giant conveyor belt.
BTW while researching this, I came across some news reports out of Nashville that the community would like CSX to "move the yard" so they can install a commuter/light rail line! This complex is the second largest yard complex in the Eastern US. Most importantly, the estimated cost to move the operation is $500 million dollars (yes, .5 billion) and I have no idea where they would move it too (let alone come up with the money to do so). CSX already occupies the most logical/reasonable site. The people proposing this are gold plated flaming *holes.
Once I built a railroad, I made it run,
Made it race against time.
Once I built a railroad, now it's done --
Brother, can you spare a dime?
Made it race against time.
Once I built a railroad, now it's done --
Brother, can you spare a dime?
Re: Whatzit?
Daisy Fleabane.
Once I built a railroad, I made it run,
Made it race against time.
Once I built a railroad, now it's done --
Brother, can you spare a dime?
Made it race against time.
Once I built a railroad, now it's done --
Brother, can you spare a dime?
Return to “The Club Car Lounge”
Who is online
Users browsing this forum: No registered users and 42 guests
